Registered User
untill my complete shave im rolling like this
by the way my "G" badging should be self explanatory.
Registered User
Quote:
Every time I do something new I notice all the imperfections – then I get used to it or ignore and don’t notice anymore… like most of us I see things on my car that most people never notice.
Mike, best way to get dead center of the trunk.......Originally Posted by OCG35
I measured and taped off prior to install… the one problem with no pins is alignment – cant use a level of course because the car itself is not exactly level… and there isn’t really a good measure point from the side… Every time I do something new I notice all the imperfections – then I get used to it or ignore and don’t notice anymore… like most of us I see things on my car that most people never notice.
take 2 pieces of colored yarn or string....run one diagonal from top left to bottom right, then run another from top right to bottom left. Once the 2 strings make an "X", where they cross will be the dead center on the trunk...then place the mt fuji there
When I was doing the "shark fin" mod for my friend's bimmer, we ran a string from the front emblem to the rear emblem to get an idea where the center spot on the roof was, perfect measurements IMO.
Quote:
take 2 pieces of colored yarn or string....run one diagonal from top left to bottom right, then run another from top right to bottom left. Once the 2 strings make an "X", where they cross will be the dead center on the trunk...then place the mt fuji there
When I was doing the "shark fin" mod for my friend's bimmer, we ran a string from the front emblem to the rear emblem to get an idea where the center spot on the roof was, perfect measurements IMO.
There is very little wiggle room… you have to remember, I covered the holes with the top of the emblem (this lowers the whole thing over an inch)… for centering right to left I lined up the point of the Mt Fuji directly between the insides of each hole (the left one is oblong and the right one is circular)… I also measured from fixed points from each taillight – but that only works if the emblem is level…Originally Posted by G Sedan
Mike, best way to get dead center of the trunk.......take 2 pieces of colored yarn or string....run one diagonal from top left to bottom right, then run another from top right to bottom left. Once the 2 strings make an "X", where they cross will be the dead center on the trunk...then place the mt fuji there
When I was doing the "shark fin" mod for my friend's bimmer, we ran a string from the front emblem to the rear emblem to get an idea where the center spot on the roof was, perfect measurements IMO.
Too far right, left, up or down and the top of emblem wont completely cover holes…
Right to left I think its pretty close… Like Papa said, no one else will probably notice the mm or 2 that it might be off…
Registered User
Quote:
lol its the g from gle off my 99 maxima.Originally Posted by OCG35
^^^ nice! Where'd you get that G?
Registered User
Quote:
lol iw as gonna say...I knew i've seen it somewhere!!!Originally Posted by darrick
lol its the g from gle off my 99 maxima.
Quote:
I like it actually... I guess its not possible to get 2 (unless someone still sells them?)Originally Posted by darrick
lol its the g from gle off my 99 maxima.
Quote:
Originally Posted by Beebo
I like the GG
at least someone has some taste
