I don't have a pic yet to actually describe this and it may be wayyyy to picky...but wanted to see if any of y'all can relate....

the small rectangular strip going across the middle of the driver and passenger side doors....

on both sides of the car, the end of the strip located closer to the rear of the car isnt flush...its peeling a tiny tiny bit - not really visible unless you're staring up close, but enough to be irritating

anyone else finding this?

 

LOL are you talking about to body side moulding?

People pay hundreds of dollars to get rid of this.

DONT take it off with out pain- there are holes behind it and the paint will be darker, due to a lack of fading.

And it is very visible, lol, WTH are you talking about?

 

haha yes the moulding...not visible because mine isnt entirely off its just a tiny tiny piece of it!

guess ill look at getting it removed and re-painted

 

If you're looking to spend some money, then get them removed and have the holes filled in before you get the doors repainted. For a cheap way out, just replace the molding... they're held on with tape or glue.

 

yeah i think its the glue thats starting to wear off...

was considering getting the aero front lip put on... and getting this also done while it was in the shop

 

just got some brand new moulding instead

 

Remove it, have the holes filled and have the entire Nismo/Aero kit molded

 

Had the same problem. Bought 3m molding tape and took care of it.

 

i have the same problem, its not that bad more like the end is a little loose. Maybe down the road i will retape or remove and repaint.

 

Dealer replaced my chipping molding under warrenty, if your still under warrenty hit them up.

 

thankfully my BSMs are perfect.