G35 Sedan V35 2003-06 Discussion about the 1st Generation V35 G35 Sedan

Anyone?

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old Jan 13, 2005 | 10:12 PM
  #1  
ABQ_G35's Avatar
Thread Starter
|
Registered User
Joined: Oct 2003
Posts: 9,054
Likes: 3
From: Rio Grande Valley, New Mexico
Anyone know what this is?

Anyone know if this is off a G35 Sedan by any chance, I found it on my driveway after I washed my car Sunday. It's about an inch wide.
 
Attached Thumbnails Anyone?-rubberbumper.jpg  

Last edited by ABQ_G35; Jan 13, 2005 at 11:48 PM.
Reply
Old Jan 14, 2005 | 12:20 AM
  #2  
Gsedan35's Avatar
Registered User
iTrader: (2)
Joined: Apr 2003
Posts: 3,288
Likes: 35
Doesn't look like something I could ID off the car, sorry.
 
Reply
Old Jan 14, 2005 | 08:04 AM
  #3  
SixFive's Avatar
Registered User
iTrader: (3)
Joined: Mar 2003
Posts: 2,873
Likes: 0
From: Philly
Are those the underbody diffusors?
 
Reply
Old Jan 14, 2005 | 08:50 AM
  #4  
G35Rhino's Avatar
Registered User
Joined: Jan 2005
Posts: 77
Likes: 0
Those may be the diffusers. I had not even noticed mine until I parked it on a hill and walked toward it from below. There were the two black plastic things pointing down in front of the rear tires. I am assuming those are the diffusers (correct me if I'm wrong). Don't know what they look like in total but what you have pictured seems like it might be them.
 
Reply
Old Jan 14, 2005 | 12:00 PM
  #5  
mikidymac's Avatar
Registered User
Joined: Jan 2005
Posts: 3
Likes: 0
I know exactly what that is, it is a tab that holds the two sections of the plastic inner fender wells together. It is just under the lip of the front fender and held on with a phillips head screw that screws into the under edge of the fender. Take a look under your fender and one should have it for reference. Just took mine off with the inner fender to adjust the drivers headlight up, didn't seem to help.
 
Reply
Old Jan 14, 2005 | 12:37 PM
  #6  
JustBrilliantX's Avatar
Misanthropic nut-cracker
iTrader: (3)
Joined: Dec 2004
Posts: 803
Likes: 0
From: On the water at the "Jersey Shore"...Toms River
Yupper....the picture is deceiving in as much as the piece is much smaller than it looks on the post . It's only about 2 to three inches in length and 1 1/2" inches wide. It's mounted to the fender edge right above the front side marker....Cool? JBX
 
Reply
Old Jan 14, 2005 | 12:38 PM
  #7  
ABQ_G35's Avatar
Thread Starter
|
Registered User
Joined: Oct 2003
Posts: 9,054
Likes: 3
From: Rio Grande Valley, New Mexico
Originally Posted by mikidymac
I know exactly what that is, it is a tab that holds the two sections of the plastic inner fender wells together. It is just under the lip of the front fender and held on with a phillips head screw that screws into the under edge of the fender. Take a look under your fender and one should have it for reference. Just took mine off with the inner fender to adjust the drivers headlight up, didn't seem to help.
Thank's, I will check it out to see if one is missing, or if it was just an extra that had been left there!
 
Reply



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 12:02 PM.