The button on my door to unlock has finally given up the ghost. it was an intermittent issue for a year or so and now it just doesn't work. I can get the panel off and get to the backside. Has anyone ever replaced this? Can you get the button on it's own or is it part of a door handle assembly and must be replaced together?

 

I think it's probably this but hard to tell from the illustration:
http://www.infinitipartsusa.com/2006...546-123382.htm

I'd also recommend testing the door's wiring harness to be sure your fault is the switch. The wires that pass through the hinge area of our doors and trunk get bent and unbent over and over again... Just a thought.

 

I have the same dang problem!

 

I'm not sure that's the correct part in that diagram. You are right, hard to tell from llustration.

The FSM is very cloudy on this area. I may have to pull the door panel and just do some testing of the lock and the wiring and go from there.