Hello everybody,

I got an used G35 from my local Infiniti dealer, and they installed a spoiler for me on it. It seems to be the standard G35 spoiler (with the break light hooked-up), but I find it a bit loose. By looking at the installation it's only screwed with 2 boat and sitting on some sort of protecting foam.

Everytime I shut a front door, it shakes a bit (ok, it's not loosed, but not as tight as it would be with 4 nuts). Can anyone confirm how it's installed on an Aero? (2 or 4 nuts)

thanks,

 

I just installed the stock wing on my 05 sedan. It has two bolts up front and two snap-in connectors in the rear with two-sided tape.

 

Does your wing shakes a bit when you shut the front doors? It seems to be installed as you described, but the 2 snap-in connectors at the rear aren't rock solid and the on the side it sits on some sort of grey foam (very thin). When I open the trunk, it seems very solid, but when I shut a front door, it shakes and seems shaky.

 

My OEM spoiler seems to shake as well. Is this normal?

 

Hey Guys,
Just installed my OEM spoiler on my 05 Sedan. Dealer will install using 2 bolts and 2 plastic clips, the grey foam is just that "grey foam". I opt to use the 2 bolts but used 2-way sponge tape (available at most bodyshops) instead of the clips. Spoiler is solid, no shaking at all.

 

Two side tape (grey foam) is probably shot and I'm doubting that the two rear clips are in place. Check out my old post https://g35driver.com/forums/showthr...950#post408950

 

i installed the spoiler myself with 4 screws two on each side of the spoiler

 

Mine was tight and definitely in place. Remove your spoiler and buy the plastic pieces from the dealer. They must be 5 bucks at most. I forgot what theyre called though...