Thanks. No. I forgot to put it on lol. But I didn't put in the sunshade stops. So it was a lot easier to just push it out the back and reinstall.

I will brush it. Just trying to figure out if I like the darker or lighter side of the suede. I do have OCD when it comes to stuff but it really doesnt bother me. Well yet anyway.

 

... Do It before you post any of your pics or I'm flagging them innappropriate!

 

I can't wait to see it when it is done.

 

damn, you have so much trim ripped out, might as well take this opportunity to sound deaden

 

I was contemplateing it but then after I did the cost estimate. Its really not something I really want to spend money on. Now if I had a crazy audio setup maybe.

 

mlv and ccf arent too bad actually like 180$ shipped for all the mlv and 70 ish for the ccf. cld tiles arent too bad either. the most expensive thing from sds's setup id say is the 3m thinsulate. you could find something else comparable and save a ton.

this one roll should be enough to do your entire car including the floors, its the one i bought
https://www.tmsoundproofing.com/mass...-100-feet.html

ccf is available on ebay 1/8" for the panels and 1/4" for the floor

 

What all did you cover? 100+ lbs for sound deadening. Jesus.

 

I Love your interior. Question... How did you paint your interior dome light... Does it come apart? I have black suede going in as well for just about everything...

 

The map light pops out of the entire trim. 4 clips. 2 front 2 back near the corners. Just use a plastic trim tool. As far as the rest of the sunglass holder and trim, I left it on the headliner and taped around it to paint it. Because it has those one way clip/washer things on pins on the backside where it attaches thru the headliner.

 

....... Mine is removed all the way.. I hope I can get my car all put back together...

 

If you lost the clips....have fun.

 

I dont know if I lost anything... I just know its out of the car...

 

I may be trying to mod a G37 one to fit anyways...

 

the clips are just little locking rings that press onto the dome light housing thing. but yeah hopefully you didnt lose them. i was thinking about retroing the g37 domelight as well but if you paint it all black you will lose the decals for open close on the sunroof and door on off because it is painted white.

 

lol this is the entire list from sounddeadenershowdown.com

Generation:
3rd
Measured Year:
2 005
Doors (each):
4 CLD Tiles, outer skin
1 CLD Tile, cut into smaller pieces, inner skin
1 CLD Tile, cut into smaller pieces, trim panel
Extruded Butyl Rope
7.2 ft² MLV
7.2 ft² 1/8" CCF
6 ft² 3M Thinsulate Acoustic
2.5 Velcro Strips, adhesive 2 sides

Passenger Compartment Quarter Panels (each):
4 CLD Tiles, outer skin
1 CLD Tile, cut into smaller pieces, inner skin
1 CLD Tile, cut into smaller pieces, trim panel
8.2 ft² MLV
8.2 ft² 1/8" CCF
7 ft² 3M Thinsulate Acoustic
2.5 Velcro Strips, adhesive 2 sides

Kick Panels (each):
.5 CLD Tiles
.9 ft² MLV
.9 ft² 1/8" CCF
1 Velcro Strips, adhesive 2 sides

Floor:
4 CLD Tiles (assumes significant coverage from the factory)
40.1 ft² MLV
55 ft² 1/8" CCF (extra is to double up in the bottoms of the foot wells)
2 Velcro Strips, adhesive 2 sides

Back Seat Platform / Riser:
3 CLD Tiles (assumes significant coverage from the factory)
13 ft² MLV
13 ft² 1/8" CCF
4 Velcro Strips, adhesive 2 sides

Roof:
6 CLD Tiles
10.5 ft² 3M Thinsulate Acoustic

Rear Deck:
4 CLD Tiles
4.6 ft² 1/8" CCF

C-Pillars (each):
1 CLD Tiles
1.3 ft² 3M Thinsulate Acoustic

* Be very careful if there are airbags in the C-Pillars. The safest course in that case is to do nothing.

Trunk Floor / Spare Tire Well (ish):
3 CLD Tiles, horizontal surfaces (assumes significant coverage from the factory)
1 CLD Tile, sides of spare walls (assumes significant coverage from the factory)
16 ft² MLV
16 ft² 1/8" CCF
5 Velcro Strips, adhesive 2 sides

Trunk Lid:
3 CLD Tiles

Quarter Panels (each):
3 CLD Tiles
5.6 ft² MLV
5.6 ft² 1/8" CCF
3 Velcro Strips, adhesive 2 sides

Trunk Back Wall:
2 CLD Tiles
7.6 ft² MLV
7.6 ft² 1/8" CCF
2 Velcro Strips, adhesive 2 sides

Totals:
59 CLD Tiles
1 roll Extruded Butyl Rope
121.5 ft² MLV
140 ft² 1/8" CCF
39.1 ft² 3M Thinsulate Acoustic
30 Velcro Strips, adhesive 2 sides
1 32 oz can HH-66 Vinyl Contact Cement

As an Order:
59 CLD Tiles @ 2.25 = $132.75
1 roll Extruded Butyl Rope @ 9.75 = 9.75
130.5 ft² MLV @ 2.11 = 275.36
11 sheets 1/8" CCF @ 15.55 = 171.05
40 ft² 3M Thinsulate Acoustic @ 3.70 = 148.00
3 Velcro Strips, adh. 2 sides, 10-pack @ 14.65 = 43.95
1 32 oz can HH-66 Vinyl Contact Cement @ 16.50 = 16.50
1 2" Maple Roller (Free w/ 60+ CLD Tiles) N/C

Sub Total: $797.36