I recently got a Mishimoto fan shroud kit and the radiator along with Hayden thermostatic fan switch. After reading few threads here I could understand the basic wiring tip from Eric@TCGMiami's post.
Red (Power, you get this from the battery)
Black (Ground, you can get it from the battery or from a nearby ground)
Yellow (Ignition On signal.. So the fans kick on when the car is on, or you can connect it to the red cable and have it on whenever the temperature reaches its target even with the car off this is how I have it)
Orange (Positive for fan #1)
Blue (Positive for fan #2)

The problem is that where do I hook up the green wire? I want the fan to stay on when the A/C is on, and remove the auxillary efan and install transmission cooler on that spot instead. where is the easiest accessible location for the A/C switch wire? I have no idea how to do the wiring for this green wire so if anyone can help I would appreciate it. Thanks.

 

It hooks to the compressor coil.....

Do you have the shop manual?

Mike

 

Thanks, Mike. I've just downloaded it. so how do I hook it to the compressor coil? The red wire from the compressor, is it?

 

Have to look
positive ( green on your box to compressor coil )
For the compressor clutch... not the one on the bottom of the compressor~

Mike

 

ATC 44/49 schematics
ATC-86 block diagram
ATC 142 the wire in step 5
Which SHOULD BE...... Blue / Orange

 

This is the info I was looking for. Thanks for your help. I can finally locate the wire!