There is a lot of used HFC/TP being sold around here. Most cases without the hardware. I was wondering if anyone knows what size bolts are normally supplied with berks, FI, or stillen. Sames goes for the exhaust.

I remember when i needed bolts for the motordyne 5/16 spacer, it was listed but then again we have the creator on roaming the boards. I dont think berks, FI or stillen are here.

I plan on installing this myself, so people saying " just let the exhaust shop handle it" isn't going to work in my case.

thanks all.

 

Berk HFC's come with 14mm M10.X 1.25 Flange nuts and bolts, 8 each.
These are for the Header to CAT, and Cat to Y. (header pipe has a stud on each side where you re-use the nut)

 

what size are the gaskets.