Sanded and prepped, ready for paint.**NOTE: These are only laid in so there are some gaps, when double sided tape is used, they are tight on the bumper** Of course it's a balmy 33 degrees in Connecticut, so I'll have to wait. Isn't it supposed to be spring?






I do have one question: Does anyone know how to remove the plastic lower mesh? I don't know if I should paint them to match the ducts or buy some new mesh instead.
Thanks for looking,
Brian

 

I recall this question being asked in the past and the answer being that you need to dremel out the mesh

 

Just need some clear and these are ready





Thanks,
Brian

 

looks great!

 

Looking good.

 

looks good cant wait to see them done

 

Sorry for the dark photos, it's overcast here. I'll take some more on a sunny day

 

looking good cant wait for some close ups when it is sunny

 

do you use 3M tape to secure those?

 

Looks stock to me...I think its kind of a waste of a rare set of face ducts...

 

^+1

 

Hmmm..... Bat sells overlays for this mod. I woulda purchased these off of you if you didnt customize them.

 

I second that, but Bat's inlet overlays are a ROYAL PITA to install and mine are already ripping and falling apart

 

I understand where everyone is coming from, but the center bar wasn't doing anything for me. I'd say I'd "wasted" them if I had cut them up and threw them in the trash, but in my eyes I see it as an improvement.

 

If you like it, than that's all that matters. BTW what did you use for paint?