When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Can finally join this thread. I'll take better pics later.
Anyone having problems with the side markers not fitting in properly? Mine kind of come out a bit towards the wheel well.
looks good...I will give you alittle secret....on the back of the markers where the metal clips are get some wood screws fairly skinny ones and use them on the backside. That will hold the markers in from popping out even under hard cornering. Once you switch to an aftermarket bumper alot of the times you will have some problems with the corners not staying in completely.
Originally Posted by b20sedan
Looks good! What mesh are you using?
Has anyone noticed any "waves" in the Kuruma Z bumper, right near the bottom of the intercooler?
you will have that issue there if you remove the mesh because thats the support for the bumper in the center. I am still rocking my mesh with my intercooler..I have a few wavy spots but thats because I lost the screws in the middle. thats the downfall of poly over time.
looks good...I will give you alittle secret....on the back of the markers where the metal clips are get some wood screws fairly skinny ones and use them on the backside. That will hold the markers in from popping out even under hard cornering. Once you switch to an aftermarket bumper alot of the times you will have some problems with the corners not staying in completely.
[/IMG]
[/IMG]
[/IMG]
