I just did a projector retrofit and CCFL my clearance lights, and now it's time to put my bumper back on... I removed the two smaller styro foam which go somewhere on the lower part of the bumper except i dont know where... could anybody let me know where to put it?

Thank you!!!

 

below the crash bar on the left and right side... look up the service manual i uploaded in the DIY section for pictures

they only fit one way so just mess with it until you figure it out

- Eric

 

I just downlaoded it and the FWD file is bad

 

all the files are bad, adobe says there was an error opening this document