Does anybody have a DIY to install a mesh on a urethane replica nismo bumper? I plan on using screws but i dont know where to screw them into the bumper.

 

usually @ the four corners of the opening but it all depends on how thick the urethene is at those points if anything you have to go to bodyshop supply store and get a special adhesive that bonds to urethene it look almost like a caulking tube

 

Raj- did u finally get your mesh? g/l on the install

 

there should be 6-8 'hard points' around the opening where you can install small screws.

 

yea man Rich refunded the money and i ordered it from customautomesh. Thanks for the tips guys.

 

just make sure you dont use lond screws make sure that are short screws! you will crack your paint if you use long screws i mean get really shorts screws for installation