Cannot start the car after change IMPUL / Mines ECU
#1
Cannot start the car after change IMPUL / Mines ECU
Hi All,
I come from Hong Kong, and I just got my 350GT 6MT JDM. By start to apply new mods, I've purchased 2 ECU, IMPUL & Mines from Japan Bid. However, after changing the ECU, no matter IMPUL or Mines, the car cannot start up, just keep on rolling the starter.
Can anyone tell me what should I do? Reset ECU or need to do any special procedure?
I've tried to follow some guides to reset ECU, just can make the CEL blink (3 slow 7 fast blinking) but no help for starting.
Million thanks for your help.
Best regards,
Kenneth.
I come from Hong Kong, and I just got my 350GT 6MT JDM. By start to apply new mods, I've purchased 2 ECU, IMPUL & Mines from Japan Bid. However, after changing the ECU, no matter IMPUL or Mines, the car cannot start up, just keep on rolling the starter.
Can anyone tell me what should I do? Reset ECU or need to do any special procedure?
I've tried to follow some guides to reset ECU, just can make the CEL blink (3 slow 7 fast blinking) but no help for starting.
Million thanks for your help.
Best regards,
Kenneth.
Thread
Thread Starter
Forum
Replies
Last Post
Hasanbaloch
Engine, Drivetrain & Forced-Induction
15
02-29-2024 08:45 PM