All DG Diamond Graphite Coupes POST PICS!
this was the test trip. Buddy dropped his bike so I figured it was a good time to see how it pulled the loaded trailer. I was worried about sag in the rear but it worked out really good with the stiffer springs and balanced trailer. I felt a little sway in corners, nothing bad, and once I get sway bars in that should help stiffen it up a bit.
well I had to cut into the rear. I was hoping it would come through the mesh but it was lower so I had to cut out the carbon/glass, but it came out pretty good. If I could do it again I'd bring in the receiver and have it raised a little so it came through the mesh. I'm not real thrilled with the mounting of the receiver. Going to get some grade8 bolts and maybe have another bracket welded to it to give some more mounting points.
well I had to cut into the rear. I was hoping it would come through the mesh but it was lower so I had to cut out the carbon/glass, but it came out pretty good. If I could do it again I'd bring in the receiver and have it raised a little so it came through the mesh. I'm not real thrilled with the mounting of the receiver. Going to get some grade8 bolts and maybe have another bracket welded to it to give some more mounting points.
I took off my door moldings. I'm thinking about taking my front mud guards off. Is there anything I should be aware of before I attempt it? When I was under the car, I think I saw a bolt or two holding it on, but its also on by 3M. Would the usual combo of WD40, sticker remover spray, and bug / tar remover do the trick without any odd looking holes?
Here's a really old picture, but its the one i found first to show the sides the best
Here's a really old picture, but its the one i found first to show the sides the best