I don't have a rear camber kit at this time and probably wont get one. I've been getting over 20K out of my rear tires (S-drives).
You will need to roll your inner rear fender with my current size or larger. The fender roll is very slight but needs to be done or there is rubbing over bumps. Otherwise clearance is still pretty roomy.

 

The projectors were retrofitted with a Acura TSX projector lens which is clearer and has a cleaner cut off then the Infiniti stock lens. The stock lens was moved into the turn signal port.

 

Luff M1? Do they come in 9.5" and 11" width? And even with that offset? I thought they are no where near aggressive.

 

My fenders are rolled, but I'm quite a bit lower than you and don't want a ton of camber. Plus, with an 11" wide wheel, I can't see myself getting anything narrower than a 295 because I'm not into the stretched look

Guess I'll have to get 4 front offsets

 

Luff's come in 8.5" and 10.5". Pics shown are with no spacers or anything. They have a pretty aggressive offset but could look better with a 5mm spacer all around, specially the front.

FYI the Luffs are no longer made so if you break one you are SOL. There are some other nice BBS LM replica options out there now with a stepped lip that I would get before the Luff's.

 

Nice! I'm a concave fan.. I've been looking for these rims but I never knew the name for them.

 

Isn't the bolt pattern on the Avants 5x120? prior post mentioned bored.
Where did you get yours?

I see they have Nissan sets for these now.
http://www.pyspeed.com/Avant-Garde-N...310-nissan.htm
33 and 35 seems bad.

 

The Avant Garde comes in the 5x114.3 I got my set from VIP Status who did pretty good.
What's wrong with 33 & 35? It clears.....

 

Badass! I love concave rims.

 

Sick wheels man. I am starting to leave the love for the deep dish and grow closer to the concave myself.

 

Integra Type-R spotted!