I am............ Im going with 19's. In my opinion 20's begin to look to big for the car... 18's look to small... 19 is just right.

 

I would say no bigger than 18's but I'm more of a function over form kind of guy

 

I have 19" oems and I find them still just a lil too small for the wells

 

20 IMHO is the best size to fill the wells.. It looks awesome esp when rolling, if your into stance then 19"s cause moar low

 

Agreed

 

Dis Agreed haha They just seem large to me.

 

Since you have fender flares, any type of wheel gap is going to look even more horrendous. I trust your 19's will have meaty tires to accommodate the TURBOOO

 

Fronts are 275x30… Rears are 325x30….. Im thinking a 19x10.5-11 in the front and a 19x12 in the rear should do it

 

Tapped down a wheel sponsor... Will be going very very aggressive and 1 off wheels... 19x10.5 -30 275/30 up front 19x12 -25 325/30 out back... offsets might get played with. Forgestars will be sold next week local.

 

Old roof was fading and had high and low spots... Was just overall failing. So I needed to re do it. Had to peel the pillars I will be re painting them so no worries there...










No clear coat. Sand till flat, bondo --- Bar lay, resin --- buff clear sand clear sand Stay tuned for final Should be in the neext few days... Maybe a week depends on how long it takes me to get to it and finish it all up. I have a Youth Group camp with 300 young men I am in charge of so yea... I may post finished pics in a weeks time.

 

on a side not I think im axing the canards and just going to run a front splitter... YEA?? or NEA???

 

AND DONE!!!!!!!! I will get the car back to my place on Monday or Tuesday, then I will be RIPPING it apart again...

 

Looks cool.
Regarding the canards vs splitter: IMO the splitter would look way cleaner. Additionally, it would provide better improvement in performance over canards. To me, it's a no brainer

 

I appreciate your input!!! BecauseI have some rear canards for the rear bumper to help mask how far out the wheels will me... I will be getting side skirt extenders that have a rise on the rear as well... So I think it will help... I think thats the direction I may take... Should look clean kinda haha...

 

Did u do the sanding and drilling to your TS1 yourself or have a shop do it?