Finally. A few pictures of everything Ive done.
Thanks for all the nice comments guys. I appreciate it!
I got a couple PMs about the door handles and trim.
The vinyl I used was from decalfx.com. I ordered about 6 square feet of it for $50. I just took a little bit of soapy water and applied pieces that I cut to fit with a wrapped card (so you dont scratch the vinyl) Then I ran the heat over it (blow dryer) to get it to stretch around the bends and to squeegee out the lifts.
Decalfx has some video tutorials on their site on how to apply the vinyl. Once I got the hang of it and figured out I could tuck the top part under the weather stripping, it wast too hard. But overall the whole job took me quite a long time and was pretty much a huge pain in the ***.
Well worth it imo
Also I'm not sure if anyone has noticed (ill have to get a better pic) that I have eyelids on my headlights. I had some left over black vinyl. All I did was lay the vinyl on the headlight and I just kinda tried to follow the lines of the hood and on the bumper. then I took the backing off and used it to make an identical eyelid for the other side. Really easy to do and I think it makes the headlights look way more aggressive!
I got a couple PMs about the door handles and trim.
The vinyl I used was from decalfx.com. I ordered about 6 square feet of it for $50. I just took a little bit of soapy water and applied pieces that I cut to fit with a wrapped card (so you dont scratch the vinyl) Then I ran the heat over it (blow dryer) to get it to stretch around the bends and to squeegee out the lifts.
Decalfx has some video tutorials on their site on how to apply the vinyl. Once I got the hang of it and figured out I could tuck the top part under the weather stripping, it wast too hard. But overall the whole job took me quite a long time and was pretty much a huge pain in the ***.
Well worth it imo

Also I'm not sure if anyone has noticed (ill have to get a better pic) that I have eyelids on my headlights. I had some left over black vinyl. All I did was lay the vinyl on the headlight and I just kinda tried to follow the lines of the hood and on the bumper. then I took the backing off and used it to make an identical eyelid for the other side. Really easy to do and I think it makes the headlights look way more aggressive!
Last edited by G35MTK; Dec 12, 2008 at 04:22 PM.
Thread
Thread Starter
Forum
Replies
Last Post
04G35NYC
Winter Setups
34
Jun 2, 2016 09:12 AM




[/QUOTE]

