New look for an old doggy door
#33
So for everyone looking into the gt spec brace it does scrape on just about every speed bump or steep incline but i guess id rather have that taking most of the hits if anything on the car. I'm bummed everyones hating on the led strips though, I've gotten a lot of good comments even from the 40+ crowd about the led's in particular. I tried to model them after the factory led strips found on the GTR not like the audi lights that tend to follow the lines of the headlights or are built into the headlight housing. Not like it matters too much but just so you all know what I was trying to accomplish.
#37
I actually like the bumper leds... kinda...
If you're going to do them, that's the right place to put them IMO, I actually considered doing it that way myself... only thing is they look "incomplete" they should go all the way across. Looks kinda strange only going over part of the duct area.
If you're going to do them, that's the right place to put them IMO, I actually considered doing it that way myself... only thing is they look "incomplete" they should go all the way across. Looks kinda strange only going over part of the duct area.
#38
#43
Looks very clean! I like it. Did you have the license plate cover molded into the bumper and redone or is it an aftermarket and you had the center cut out? It's unique. I'm digging it.
I would also opt for Nismo Side skirts. Think they'd go well with the overall look, since your front bumper and 05/06 rear bumper flare at the bottom.
Really like the interior, very nice touch.
rob.g
I would also opt for Nismo Side skirts. Think they'd go well with the overall look, since your front bumper and 05/06 rear bumper flare at the bottom.
Really like the interior, very nice touch.
rob.g
#45
I paid $400 for the exhaust to be installed but I bought the magnaflow mufflers separately which was another $250 and also moved my fuel evap canister from under the car to the trunk by myself in a couple hours for about $50.