JDM Cain's 03 Sedan Progression Thread
#676
#678
I was able to install a Weapon "R" PS Tank easily in front of radiator/condensor with basic brackets and slight mods to tank mounts. Challenge is the plumbing, alot of AN fittings needed.
Finishing up some loose ends. Getting ready for show car season.
Need to cover the new overlays that replace the rear seat area, install the Magnaflow X Muffler, re-adjust transmission line pressures and have it Dyno Tuned Again.
Chris all the mods you've done are well executed and sure the PS Tank relocation will be the same.
Good Luck
The following users liked this post:
JDM_Cain (02-05-2013)
#679
The following users liked this post:
JDM_Cain (02-05-2013)
#680
#681
Happy to help where I can dude, can't wait to see that come up in these pages
Which reminds me, I think it's about time I put a progress thread together for my own Jalopy. I was going to hold off until it was 'done', but I've jammed a large dam into my money flow into the car for a while, so might as well.
Once the Dyno/Tune is done, perhaps.
And thank YOU for all your help and inspiration, to me and to everyone else in awe of your scrutiny and attention to detail, along with the DIY stuff, which I love to see, especially on a forum where the bulk of members pay someone else to do everything for them (not that there's anything wrong with that!)
Which reminds me, I think it's about time I put a progress thread together for my own Jalopy. I was going to hold off until it was 'done', but I've jammed a large dam into my money flow into the car for a while, so might as well.
Once the Dyno/Tune is done, perhaps.
And thank YOU for all your help and inspiration, to me and to everyone else in awe of your scrutiny and attention to detail, along with the DIY stuff, which I love to see, especially on a forum where the bulk of members pay someone else to do everything for them (not that there's anything wrong with that!)
The following users liked this post:
JDM_Cain (02-06-2013)
#683
and so....the 2013 changes begin. I needed funding for a different project, therefore had no choice but to sell my ARC induction box and Pipe. Ill be rolling on OEM for a while I actually like it
I spent last evening watching the Lakers game and polishing my gems for their new owner.
They have since been shipped out.......stay tuned for changes to come..
I spent last evening watching the Lakers game and polishing my gems for their new owner.
They have since been shipped out.......stay tuned for changes to come..
The following users liked this post:
TunerMax (03-18-2013)
#684
The following 3 users liked this post by dominate:
#688
The following 9 users liked this post by JDM_Cain:
617DG35x (04-16-2013),
DVG (04-16-2013),
G35CDriver (04-17-2013),
G35Papa (04-17-2013),
gambit2083 (04-16-2013),
and 4 others liked this post.