The rear has to come up about an inch and then the next thing to be ordered will be upper control arms for the front.

 

Nice drop bro.....how about you just drop the front an inch instead??? Jk. I'm always gonna go for more low.

 

I would if I could.....the front is all the way down.

 

What front control arms are you looking into? From what I read before, the only ones that don't knock on slammed cars are the SPL arms, but unfortunately they don't make them for our cars.

 

Looking good man

 

Thanks!

 

clean paiting ... nice work

 

Not sure what you mean here but thanks!!

 

After having to replace a set of tires after only 8 months I ponied up and bought a set of SPC control arms and finally installed my SPC toe bolts. Here it is getting aligned this afternoon. The only part that sucks is that we were able to get the rear toe in spec but the camber is sitting at -2. Going to raise the rear about a 1/2" or so and see if it corrects the negative camber. On the flip side the front is all the way down on the coils and is in spec!!

 

i would say 20mm spacers all around! should do u right!

 

Yeah I am waiting until I get all of the alignment straightened out then will measure for spacers.

 

sweeeet!

 

So it is decided...wheels are coming up very soon. Going to go with enkei RPF1s in a 18x9.5 et 38 and 18x10 et 38. What do you guys think of the offsets / width? I am trying to get the flush look. Do you think I will still need spacers to get them sitting just right? I know some of you might think 18" is to small but I think I can pull it off.

 

Oh yeah and raised the rear up on Monday so it will be back to the alignment shop for me.