Welcome! Im from columbia,

 

Welcome! I'm from the O'Fallon/Lake St. Louis area.

 

hello again and welcome.

 

i'm in St. Charles! Gone to Boston for work till July 6th really looking to go to a meet or a cruise if anyone is down!

 

I would almost be willing to drive the 2 hours for a cruise just to see some other G's. Nobody does that kind of stuff around here.

 

same here ive heard of one meet and of course i'm outta town for it.

 

just got done with engine dress up: painted my plenum black, new cover, bolt and strut bar refinishing. Check it out in my album (some reason driver doesn't let me attach any pics to my msgs)

 

Looks good. Engine dress up is next on my list.

 

There's a DIY on this site for the bolt dress up part. Allenfasterners.com is the best, I got all the bolts and washers for my engine bay and undercarriage for around $30. I used rustoleum metallic paint for the washers; all in all took 30 minutes to switch every bolt not counting paint time.

 

what paint and grit sandpaper did you use to spray your plastic with?

 

400, then primer, 1000, rustoleum high performance enamel gloss black, then light coat rustoleum crystal clear enamel

 

holds up pretty good? i was thinking about painting my z tube. prob use high temp paint though.

 

It's held up fine, painted those in winter. The high temp stuff like engine enamel doesn't really work well with plastics in my experience, you will get alot of runs. The technical data for the high performance enamel rates dry heat threshold at 200F, don't expect my plastic to get that hot. Also, as far as rattle can paint, it is the best I have used as far as coverage and atomization at the tip; really consistent paint behavior each time I spray.

 

I would be down for a meet and greet.

 

hey guys i got some springs for sale!

350z s techs $120
350z stock springs $60

If you would like both i will negotiate a better deal! I got a pic of my car with the s techs in the front and stock z springs in back. nice rake if you not looking to go way low! No camber kits are needed with the s tech/ stock z spring combo!

[IMG][/IMG]