Seen it in person at his shop in AL. His work is real clean. Drove down there from TN in my boys K20 eg hatch to get some modifications done to the Milspec harness that he got. I asked Chase if he would start making vq harnesses for our chassis. His response was " if the demand is high" I have been talking to him for awhile about making me a one-off harness.
If you guys are really interested PM me.
you can check out his work
http://www.chasebays.com/

 

what kind of plenum are you running, doesn't seem to have the 6 bolt holes in the center like the oem?

 

^Its OEM, he filled in the holes.

 

 

^Lookin' good so far. Did you weld your coolant pipes or cap them off?

 

thanks. the coolant pipes are all welded. and i couldnt get anyone to weld the t-stat up in time before i put the new motor in so i just got some coolant bypass caps and stuck one on that nipple lol

 

You can use the hr t-stat it does not have a nipple. I actually drill and tapped mine with a plug.

 

+1 on the HR thermostat, works perfect n it's only 30bucks

 

Wish I knew about that when I did mine. I got a nismo tstat and put in a plug.

 

What temp is the HR 'stat?

 

ahh, interesting. lol never paid attention to the HR one although i do remember looking hard enough to notice they looked the same bolt-wise

 

Probably higher temp than oem since it doesn't have the extra nipple that recirculates hot coolant

 

A lil teaser for now

 

^Baaaaaalin'!