Goodbye JBF G, hello JBFD3S!!!
#98
This build is going much slower than I wanted it to but I've been so busy with other things in life and the JBFD3S has been the last thing on the list to worry about.
Waiting on custom parts for months is kind of a buzzkill too. I couldn't do anything with the engine bay until the turbo manifold showed up and of course, I needed to get the lower intake manifold modified to work with everything...so I'm still waiting to throw the motor back in.
But I'm still ordering parts and getting everything together to make the final part of the power build go quick once the motor is back in.
That being said, fedex just delivered some Vibrant -6AN fuel line and an Aeromotive 340 fuel pump. I ordered them from Assaultech here on the forums so I'm gonna show them some love when the build is over.
Waiting on custom parts for months is kind of a buzzkill too. I couldn't do anything with the engine bay until the turbo manifold showed up and of course, I needed to get the lower intake manifold modified to work with everything...so I'm still waiting to throw the motor back in.
But I'm still ordering parts and getting everything together to make the final part of the power build go quick once the motor is back in.
That being said, fedex just delivered some Vibrant -6AN fuel line and an Aeromotive 340 fuel pump. I ordered them from Assaultech here on the forums so I'm gonna show them some love when the build is over.
#101
Few more updates...
New carpet from Stockinteriors.com
Tanabe touring medalion rear exhaust section, RE-Amemiya Street Diffuser, AEM UEGO wideband, oil pressure, water temp gauges, custom engine harness for single turbo setups, metric to NPT compression fittings for my stock fuel hardlines to run -AN lines, detailing goodies from one of the sponsors, and some bulbs from the guys over at sylvania.
AND...a new gauge face cover and trim for the stock gauges...the old cover was shiitty and the chrome rings were faded.
Top = old
Bottom = new
Also in the works, a custom Greddy V-Mount intercooler kit and a Sanai works front bumper.
New carpet from Stockinteriors.com
Tanabe touring medalion rear exhaust section, RE-Amemiya Street Diffuser, AEM UEGO wideband, oil pressure, water temp gauges, custom engine harness for single turbo setups, metric to NPT compression fittings for my stock fuel hardlines to run -AN lines, detailing goodies from one of the sponsors, and some bulbs from the guys over at sylvania.
AND...a new gauge face cover and trim for the stock gauges...the old cover was shiitty and the chrome rings were faded.
Top = old
Bottom = new
Also in the works, a custom Greddy V-Mount intercooler kit and a Sanai works front bumper.