All Black Obsidian Coupes Post pics!
#3409
06-17-2013, 03:48 AM
#3410
06-17-2013, 06:51 PM
Hey OBsessed,
Do you know your fender to ground measurements? I've got the same tire sizes and almost the same width 19x10 / 19x11 and curious at a good starting point to shoot for when adjusting my coils.
In your KF ad, it also looks like you have room to adjust the camber more positively, or are the pics deceiving? Sometimes the tires are so black you can't see how close they are in pictures.
thanks
Do you know your fender to ground measurements? I've got the same tire sizes and almost the same width 19x10 / 19x11 and curious at a good starting point to shoot for when adjusting my coils.
In your KF ad, it also looks like you have room to adjust the camber more positively, or are the pics deceiving? Sometimes the tires are so black you can't see how close they are in pictures.
thanks
Also on the front camber - with the tires that are currently on it (225/40 RE050A) there's more of a gap for some reason than I recall having with the first set (225/35 Hankook V12). I'm dong screwing with it until I get some stockers back on and go back to an OEM or almost OEM alignment spec so it's kind of in limbo at the moment.
The following users liked this post:
TGMcCoy (06-17-2013)
#3412
06-17-2013, 08:08 PM
Rear camber definitely couldn't get anymore positive, still rubbing on dips at -5.1, front camber is iffy, it's at -3 right now and anymore positive would make the rears look even more ridiculous and cause problems at full lock turning without more of a pull. In those pics the fender measurement is probably somewhere around 25" I think, at one point I was below 24 and then I kinda lost track of where I ended up, I raised it a couple times in small increments and don't even know if I've done so again since then...
Also on the front camber - with the tires that are currently on it (225/40 RE050A) there's more of a gap for some reason than I recall having with the first set (225/35 Hankook V12). I'm dong screwing with it until I get some stockers back on and go back to an OEM or almost OEM alignment spec so it's kind of in limbo at the moment.
Also on the front camber - with the tires that are currently on it (225/40 RE050A) there's more of a gap for some reason than I recall having with the first set (225/35 Hankook V12). I'm dong screwing with it until I get some stockers back on and go back to an OEM or almost OEM alignment spec so it's kind of in limbo at the moment.
#3413
06-17-2013, 08:44 PM
#3414
06-18-2013, 08:43 AM
Negative. Got a sweet deal on used tires, lol. They were close enough to spec so threw them on.
The following users liked this post:
TGMcCoy (06-18-2013)
#3415
06-25-2013, 10:29 PM
#3416
06-27-2013, 03:35 PM
#3418
06-27-2013, 05:27 PM
The following users liked this post:
jookyshank (07-02-2013)
#3420
07-02-2013, 02:16 PM
