Help please... Throttle body not fastening.
#1
Help please... Throttle body not fastening.
I tried installing the cooper throttle body heater that came with my motordyne plenum spacers, but while i was attempting to fasten the bolt with a torque wrench i heard a pop. I thought i broke the bold, but after taking it apart again, the bolt seems physically fine. Only the bold that i attempting to tightnen is not holding.
Any idea why this bolt is not holding? What can i do about this? There's no way that i can get away with only 3 bolts fastened correctly?
Any idea why this bolt is not holding? What can i do about this? There's no way that i can get away with only 3 bolts fastened correctly?
#2
The goblin resurrection
iTrader: (66)
First... you posted this in the classified section. Not were you would get a proper response.
More than likely you over torqued it and stripped the threads in the manifold. You will most likely have a vac leak if you use only 3 bolts.
You will have to re tap the manifold for the next size up.
More than likely you over torqued it and stripped the threads in the manifold. You will most likely have a vac leak if you use only 3 bolts.
You will have to re tap the manifold for the next size up.
Thread
Thread Starter
Forum
Replies
Last Post
RemmyZero
V36 DIY
10
04-23-2018 11:13 AM