Hey guys, if anyone is interested there is a dyno day in Downey on Saturday - all different kinds of car. They're doing 3 pulls for $40 or 3 pulls with a/f for $50.

The shop has 2 dyno's, so they can get through a lot of cars in a day. They use a dynojet 224. The last one was a lot of fun - all different kinds of cars: Mustangs, Vette's, S2000's, a super cool turbo Dodge Omni, SRT4's, RX7's, a Supra or two, etc.

I'll be going at some point during the day and I'll be taping runs so if you come hopefully I'll get one of yours. The address is: 8107 Phlox Street, Downey, Ca 90241.

Original thread is here.

See you guys there!

 

i didnt know this was in downey, too bad my car is stock

 

Come get a baseline, the price is right. It's a super cool crowd, no jerks.

 

Sounds interesting and very local. Hopefully i can come by.

 

I'll be there at least part of the day, hopefully I'll run into you. My name is Sean and I have a white 04 Mustang Cobra.

 

I'd go but all I got is a torque damper :P

 

Get a baseline, then you'll know how far your mod money is going

 

Bump.

 

To bad my fully built N/A motor isn't done yet

 

It sounds cool since i don't know how much power i am getting to the wheels. Would be nice to know but i have to work that day. SUCKS!!!!

 

Definitely too bad. What are the specs on the motor?

 

My build
-Cosworth Forged Piston Set 96mm Bore 11:1 comp
-Scat rods
-Cosworth High Performance Head Gaskets
-ACL Race Main Bearings
-ACL Race Rod Bearings
-ACL Race Thrust Washers
-ARP 12 Point Head Stud Kit
-ARP Main Stud Kit
-Brian Crower Valve Spring Retainer Kit
-Cosworth "Rev up" ZK1 Cams -Intake 268deg. 10.4mm lift / Exhaust 268deg. 9.5mm lift
-Custom Port and Polished Intake Manifold Plenum
-Full Bolt-ons

 

Sounds awesome. What's the displacement? How much hp are you shooting for?

 

Thanks, Im not sure yet just some thing fun to drive. Ill have numbers soon!!! tho