General, do you have your three friends names? If so, add them so I can show the shop owner a list of names...thanks.

 

I'll I do three separate runs so that makes at least 10. This should make the dyno shop owner happy.

 

So you mean you'll do 9 pulls total? For $150?

 

Hey randy, where is this shop? I'm thinking I need to find a dyno soon so that technosquare can be more accurate with my fuel numbers. I'm a little worried because tadashi left my car a little lean temporarily and im still detonating.

 

I just PM'ed you.

 

Yeah its a lot but gotta do it.
3 runs at 3 pulls each for $150 unless I can do 3 runs at 2 pulls each for $100.

Either way I need to do 3 runs to test 3 conditions.
1) Baseline
2) Plenum mod
3) Modification of a Stillen Exhaust

Both the Plenum and Exhaust mods are my own design so there is no hard data to say what they do. Multiple dyno runs are the only objective way to quantify the effect(s).

BTW Where is the dyno shop? I have many more mods/dynos to do in the near future. If the shop is good I would like to go back for repeatability of dyno & A/F measurements. It would also be very, very helpfull if their data could be exported to disk for additional analysis.

All this data will be going to TechnoSquare for a good tuning on the VQ. I'm sure my engine is running lean with all the highflow mods getting slammed on.

Stillen CAI, X.L. plenum spacer, headers & cats (soon to be installed) and a modified Stillen exhaust (for much lower flow resistance).

 

The place is called Harman Motive I believe...it's in my wallet. I'll give details right after the holidays when we come up with a date.