PART OUT :
Genuine VRT strut bar with ALL necessary hardware (4 bolts, 4 nuts and the washers to go with it)
I tried couple other bars that were secured by the six strut tower nuts in the engine compartment and they did NOT compare!

If you like a stiffer feel to your car, this strut bar will make a huge difference. Not only will you notice the difference on mountain roads, you will notice it backing out of the garage or driving through a parking lot. It completely changes the feel of the car.

Unlike other basic bars, this bar attaches to the bolt that secures your upper A-Arm. The front end of the car has to be off the ground to get the bar secured. Upon lowering the car to the ground, you can see the parts engaging as the bar actively stiffens while the car is at rest.

If you enjoy on ramps, off-ramps, turns, mountain roads, this bar is a MUST!
$380 shipped + PP fee OBO
PM me for additional photos

Adrian

 

300 shipped to cali??

 

replied via PM

 

Will this fit over engine cover? And any hood rubbing? Thx!

 

Legit seller. G35 veteran

 

it fits in front of the engine, It does not go across the top! You will have to cut the OEM engine cover to make it fit. No hood rubbing at all. It's a completely different design from most and the original VRT bars are great quality!

it fits like this


I have a stillen intake that I had to trim a little to fit somewhat like this except it retains the more stock-looking box which is great to decrease the intake of hot air from the motor



Thanks!

 

Sold sold sold!!!