Using Bosch sensor w/ Innovate LC-1 in place of stock sensor?
Joined: Jul 2005
Posts: 773
Likes: 0
From: Goodyear, AZ
Using Bosch sensor w/ Innovate LC-1 in place of stock sensor?
I recently picked up an Innovate LC-1 w/ Bosch wideband sensor. I was reading through the manual and it states that the Bosch sensor can be put in place of an OE sensor, and the LC-1 can output an analog 0-1V output to the ECM. But, I've searched around and haven't found anyone that is doing this. It looks pretty straight forward, and it'd save me from having to install another bung (not that big of a deal). Also, the location on the driver's side manifold seems pretty ideal.
Input/comments?
Input/comments?
Joined: Jul 2005
Posts: 773
Likes: 0
From: Goodyear, AZ
Disregard. I just dug into the FSM and discovered that the sensor in the manifold (A/F Sensor 1, Bank 2) reads 1.5V at an A/F mixture of 14.7....
Oh well. It was worth a shot.
Oh well. It was worth a shot.
Thread
Thread Starter
Forum
Replies
Last Post
THMotorsports
Suspension-Vendor
257
Dec 18, 2018 05:43 PM
Mad A
Not G35 Related
4
Dec 8, 2015 01:45 PM
