same as the topic.
I'm wondering could the V36 X do all 4 corners with 20 X 10 +35mm like those hella flush STI


Colour: Machined Black with Chromed Stainless Lip or Machined Black with Chromed grooved lip or Black with Chromed Stainless Lip??
RIMS: 20 X 10 +35 or 20 X 10 +40 or 20 X 8.5 + 35??
Tire: toyo t1 R 245 35 20 or 235 35 20??
Please help me out to complete my car.

 

rear i know you wont have a problem at all but 20x10 out front not sure about that

 

yea Im worrying about the front too..
since most likely people would only put 8.5-9.5 for the front ><

 

awww... i know nothing about camber......
so i will need to get a camber kit ??? but i know there's only rear camber for the X, so how about the front?
and can i run with toyo t1-R 245 35 20 then?

 

It'll fit fine with some camber.
If you're going to lower your car a decent amount you probably won't even need a camber kit. H&R springs would give you the camber you need.

 

It will fit without any problem.... just make sure you utilize the camber. What are you lowered on?

 

I dont worry about the rear, Im just after the front will have rubber issue

 

I wonder what the heavier and wider front wheel/tire combo would have on steering...

 

this is one of my concern too.... lol ..
but I dont mind it heavier because i used to drive a 02 mini with 18 X 8.5 on it with electrical steering which my Gf hates the most haha
I'm just afraid of the front sticking out way too much with a 10 instead of 8.5

 

If you're going to stretch your tires, why would you worry about performance? Stretch tires = negative on handling.

 

I dunno if this is helpful for you but I drive an X as well.

I have rims on order right now. The size is 20x9 +38 all around.

 

Im having 20 X 8.5 +38 right now.. thats why i wanna go wider.... however i think i will give up on 20 X 10, but go for 20 X 8.5 +20 mm for all 4s.......
So, i just need someone to tell me +20mm will work fine ...

 

Yeah that'll also fit fine.

 

I fit 10 with a +30 offset up front on mine, you would need a bit of camber....I'm not sure how low you are going but it will look great.the rim came really close to the control arm but i would say there was at least a 10 mm gap in between the two. I'm not sure if X control arms are the same but you should probably find someone with close to that spec wheel to test them. They work fine on RWD models