Is this possible on the 2nd gen with minor fender pulling/ tire stretching btw car is slammed about 3 in..

 

IMO, offset is too low even with fender pull

havnt seen anyone with offset under +20 on v36.

 

Fronts would fit with stretched tires and a generous amount of camber but the rears would need some fender work to make them fit.
Might be able to fit it with stretched tires, an aggressive pull, and a good amount of camber dialed in. Widebody would be best.

 

It will work w/ stretched tires, flared fenders, and lots of neg chamber.

 

hm........ even my 9.5 + 20 stick almost 3/4 inch with around -2.9 camber...
how would a 10.5 +12 fit ?? 10.5 + 12 with 235 tires?? and -4 camber ??? why would anyone do that to harm the tires ???

 

Like everyone else said you'd have to do some massaging with tire stretching and camber. I think the fronts should fit with a slight stretch while the rears will require a good amount of work.

I'm currently running 9 +20 and 10 +30 on my setup with no problems. Camber settings are at -1.7 and -1.3 for the front and rear respectively. Fronts are out of spec per manufacturers recommendation but rears are in spec (barely!!). Check out "heyitsalex" ride, he's on 9.5 +17 and 10.5 +24 if I'm not mistaken...