Ok so tomorrow i will be installing the SPC camber kit but i am a bit confused on one part. its the part where i have to put this metal bracket in to the right position (see pics below)

i am dropped on BC coilovers and i was wondering what position i have to put this bracket in i guess i want the fronts to be close to factory...

Or do i not even have to worry about this cause the alignment shop will take care of it???



what position its on 0 degrees right now



here is the chart

 

I left mine on 0 degree caster.

 

From looking at the picture above, it is already dial up to 0