It's Heeeeeeeeere!11!1one (nx)
#16
06-12-2009, 09:18 AM
#17
06-12-2009, 11:16 AM
#20
06-12-2009, 03:42 PM
My 1/16th NPT fuel tap and my 1/16 to 4AN adapters shipped yesterdy USPS Priority from 2 states away, so I should have all the parts in time to install this weekend. Thank god for Saturday usps delivery.
A few thoughts...
The ZEX nitrous kit for the vq35HR motor is probably the easiest to install. It comes with an adapter that actually connects directly to our fuel line's quick disconnect. No drilling/cutting.
The DynoTune nitrous kit is the next easiest (and least expensive) to go with. They offer the option of providing a pre-tapped fuel line so you can have your stock fuel line handy if you ever need to bring it in for service.
The NX kit was the only one that was not model specific. The parts are top notch, but I had to get some extra pieces to drill/tap into the fuel rail.
On a fail note... Nitrous is going for $4.75 per gallon at my local speed shop. Almot 50 bucks to fill a 10lb bottle which will probably give me about 15 runs with the way I have it set.
A few thoughts...
The ZEX nitrous kit for the vq35HR motor is probably the easiest to install. It comes with an adapter that actually connects directly to our fuel line's quick disconnect. No drilling/cutting.
The DynoTune nitrous kit is the next easiest (and least expensive) to go with. They offer the option of providing a pre-tapped fuel line so you can have your stock fuel line handy if you ever need to bring it in for service.
The NX kit was the only one that was not model specific. The parts are top notch, but I had to get some extra pieces to drill/tap into the fuel rail.
On a fail note... Nitrous is going for $4.75 per gallon at my local speed shop. Almot 50 bucks to fill a 10lb bottle which will probably give me about 15 runs with the way I have it set.
#24
06-17-2009, 05:44 AM
#29
06-21-2009, 06:14 PM
god i've been wanting to do this, i just don't have the change right now. here is my vision:
i don't have any switches where the "seat heaters" and "snow mode" go (my car is 'stripped') - i was going to install these factory switches in their respective spots and make them control the NOS bits, ie bottle on/off, heater on, etc.
then... i have a 6MT. i was going to install the paddle shifters from the AT cars, and use these to actually actuate the nitrous spray when i want it. and waa-laa - a completely hidden, factory look NOS system! i'm thinking 50-75 shot, i'd rather be conservative than out a motor.
now i just need 3 or 4K to blow.
good luck with the install, please post pics/vids etc when you're done.
i don't have any switches where the "seat heaters" and "snow mode" go (my car is 'stripped') - i was going to install these factory switches in their respective spots and make them control the NOS bits, ie bottle on/off, heater on, etc.
then... i have a 6MT. i was going to install the paddle shifters from the AT cars, and use these to actually actuate the nitrous spray when i want it. and waa-laa - a completely hidden, factory look NOS system! i'm thinking 50-75 shot, i'd rather be conservative than out a motor.
now i just need 3 or 4K to blow.
good luck with the install, please post pics/vids etc when you're done.
Last edited by infinitipearl; 06-21-2009 at 06:15 PM. Reason: misspelling