Well, I **thought** I was going to install my newly purchased wheel spacers today, and go to find out the hubcentric ring built into it doesn't fit into my OEM 19" Rays. Anyone put spacers on your OEM 19s? If so, what kind, where from? Thanks.

 

How is it not fitting? What size spacers? You either bought the wrong bolt pattern, bought smaller spacers with built in lugs that causes your stock lugs to block the rims from fitting, or if you are talking about the fronts didn't remove the little metal piece blocking it from being installed.

But just in case, I ran project kics and ichiba v2's 25mm spacers on my oem rays, if you want to buy them just pm me.

 

Did you get the ichiba V2? I got mine from B2...vendor on here, I think they are in FL too.

 

It appears to be the hubcentric ring that is built onto the spacer....it doesn't fully fit into the back of the OEM wheel. The hole appears to be tapered on the wheel itself...and on the spacer, the ring is not tapered. Atleast, that's what it looks like.

 

Please describe what spacers there are the be sure your bolt pattern and everything is right? Where did you buy it from?

 

They're off of ebay. Bolt pattern is fine....it's just the hubcentric ring doesn't fit into the rim. Listing specifically said it'd fit my car, guess not, unless they sent me the wrong one. Hopefully they refund me!

 

eBay. That's your problem.

 

+1 id never run cheap eBay spacers on my car

id rather not have my wheel come off while doing 80 on the highway