19" SBC RPF1 w/Eibachs on DG Coupe
#5
#6
I believe they were 22 offset all the way around, I'll have to check with the guy. I had a special deal on these, just paid for the springs. No install fee, no mounting or balancing, tires, wheels, lugs, etc.
The SBC finish is actually really nice in person, much better than the pic on the Enkei website. No big lip but still looks pretty clean IMO. The rear wheels (Hard to tell from pics) is like the Volk te37 where the spokes curve (dont know the term) just not as much.
Weight on the back wheel without tires was 19.xx with a shop scale. With tires, I believe is was very low 40lbs but I will have to check again on the weight with tires.
Thanks for the positive comments.
Front 19x8.5 245/35/19
Rear 19x10 275/30/19
The SBC finish is actually really nice in person, much better than the pic on the Enkei website. No big lip but still looks pretty clean IMO. The rear wheels (Hard to tell from pics) is like the Volk te37 where the spokes curve (dont know the term) just not as much.
Weight on the back wheel without tires was 19.xx with a shop scale. With tires, I believe is was very low 40lbs but I will have to check again on the weight with tires.
Thanks for the positive comments.
Front 19x8.5 245/35/19
Rear 19x10 275/30/19
Last edited by SloG35; 06-27-2005 at 03:07 PM.
#7
Trending Topics
#10
Those RPF1's look awesome in SBC. However, be extremely careful about potholes. I believe that the SBC finish is a spray on type chrome (to keep the rim lightweight) so you can't refinish the wheel by using a traditional chrome dip. It was really hard for me to pick the F1 silver instead of SBC. But I'm glad I did since the roads in Texas are filled with potholes. https://g35driver.com/forums/dfw-g35-owners-club/52851-bent-rim-repair-dfw-area.html.
#11
#15
Sorry for the delayed response..... they are holding up perfect, no difference on the finish...
http://spaces.msn.com/members/slog35/
Theres an album with pics on there.
http://spaces.msn.com/members/slog35/
Theres an album with pics on there.
Thread
Thread Starter
Forum
Replies
Last Post
djreinx
Engine - Electrical
3
12-10-2015 01:48 AM