I have an almost new set of Headgames heads for sale, that were a back up set for my car.I no longer need them, and will sell them.The specs are the following:
Street/Race Port,5 angle valve job
Ferrea DUAL valve spring kit,valves,springs,locators,locks,Titanium retainers
All New Nissan OEM valve buckets
Ferrea VITON Exhaust and Intake Valve stem seals
Cam lash set
JWT S1 cams installed.
Retail for heads and cams would be about $6000
Im asking $4200 shipped VERY FIRM no lowballers and noballers..
No CORE needed!!


Also have 2 sets of OEM heads for sale for $500 per set shipped
And I have 1 OEM 5speed Auto tranny for sale for $800 shipped 1000 miles on it..
Will seperate the heads from the cams, asking 3500 just for the heads.

 

bump

 

What kind of gains can you expect from a mod like this?

 

It will increase the abilty of the motor to flow air in and out.Your motor is basically a big air pump, and anything you can do to make it more efficient increases its ability to make power. A solid HP number depends on factors like Turbo sizing, Cams, Timing, Compression ratio, Ect..
These heads are the REAL DEAL as far as heads go and will give your engine 8000-9000 RPM ability without Valve float...Another good thing about the Ferra Valve train is their strength. If somehow Piston to valve contact occurs, the valve will not Shatter in tiny pieces and destroy the entire heads...These heads have been on some record setting cars, including Performance motorsports 8 second Street car.

 

bump

 

trade for iforged rims and cash?

 

how much power will these add heads and cams to an 06 coupe

 

No thank you. I want to ge the cash for them.

 

These heads are made for a F/I car really..On FI you can expect 50-80whp.Dont really know if it would help on a N/A car, but the heads are made to rev 8000-9000rpms.

 

i am gonna fi my car im just tryin to decide if i want to rebuild the whole motor while im at it

 

Bump..