SOLD Replaced the wheels so these are no longer needed. $30 or OBO. Buyer pays shipping and paypal fee.
I'm also selling my wheels if you want to take a look at those.
www.studio3commercial.com/wheels
I'm also selling my wheels if you want to take a look at those.
www.studio3commercial.com/wheels
They are hub centric and yes they will work with any wheel for the G35 and many Nissans in general.
Registered User
could you tell a difference? 5mm is very small lol I probably need 15 or 20mm but I don't really want to spend money on them since it's not that big of a deal. My wheels aren't flush, but would 5mm make any difference really?
It's totally subjective. I didn't want my wheels to exceed the fender but I wanted to push them out slightly. 5mm is just over a 1/4 of an inch. For me it worked. You would have to decide for yourself based on how much you want to push the wheel and tire out. The difference really shows up when you look from the back and front of the car.
If you have a wheel pattern that meets the following specs then they will work.
Bolt Pattern: 5/114.3
Center Bore: 66.2
This is a standard wheel pattern for Nissans, Infiniti, Toyota, Lexus and some Hondas.
Bolt Pattern: 5/114.3
Center Bore: 66.2
This is a standard wheel pattern for Nissans, Infiniti, Toyota, Lexus and some Hondas.
Registered User
Not to sure about the center bore... but bolt pattern is 5x114.3...
These just sit behind the rim right, no need to take anything else off
These just sit behind the rim right, no need to take anything else off
No you don't have to remove anything. These go between the wheel and the rotor.
