car will not start
#18
Join Date: Jan 2004
Location: Centerburg, Ohio (the geographical center of the Buckeye State)
Posts: 1,254
Likes: 0
Received 19 Likes
on
4 Posts
connect eveything back like stock, off the 12V lighter and see what happens.... maybe shortcircuiting off cigarette lighter wires...
You might want to take it to Autozone or somewere that has OBDII reader who can give you fault codes. That way you can pinpoint exact problem where shortcircuit is. Did you check fuse block near in front of the battery as well as the driver foot well near the dead pedal?
keep us posted....
You might want to take it to Autozone or somewere that has OBDII reader who can give you fault codes. That way you can pinpoint exact problem where shortcircuit is. Did you check fuse block near in front of the battery as well as the driver foot well near the dead pedal?
keep us posted....
#19
#20
#22
#23
Join Date: Jan 2004
Location: Centerburg, Ohio (the geographical center of the Buckeye State)
Posts: 1,254
Likes: 0
Received 19 Likes
on
4 Posts
Originally Posted by WGS
I'm not the expert, this is the invoice "found codes #U1001/U1000. Repaired ECM ground terminal". Total cost $348.60 plus towing $230.0 for 20 miles. And The extended warranty does not cover it, bc nothing was brocken.
I guess the most important question is "Does you car start up now?"
It looks like they did the OBDII scan and found those codes U1001 and 1000. I'll try to doing some research in the service manual on these codes.
doc
#26
#27
figured it out.
Originally Posted by princcipepersia
Guys, I'm having the exact same problem. I checked all the grounds. This only happened after I tested the reverse camera by simmply putting the car in reverse. When I didn't see a picture I turned it off and now it won't start. Any ideas?
Thread
Thread Starter
Forum
Replies
Last Post
kenthung
G35 Coupe V35 2003 - 07
0
07-21-2015 05:56 AM