I just pulled my stereo and put the stock stereo and AC control back in. Now I don't get any power to the stereo or AC, just a single loud beep and then that's it. Nothing lights up...nada. However, it does sound like the CD motor is trying to do something.

I didn't cut into the harness at all, but used a wiring adapter. The stock amp and NAV brain have all been put back in.

The only thing is that I have 4 ohm speakers in the back that I don't even want to try and remove, so I have a 2 ohm signal running into 4 ohm speakers in the back, but I can't imagine that would keep the stereo from even firing up.

Any thoughts guys? Your feedback would be GREATLY appreciated.

Thanks

 

Theres a little hidden wire that runs from the circuit board to the radio. Is that in?

 

What hidden wire?

 

check fuses, make sure everything is plugged in

 

I just had this problem happen and searched on here for the solution but couldn't find one!! What it was is that there is a small green film insert plug that connects to the back of the faceplate at the bottom right hand side. Somehow that came out when I pulled the head unit and and I started checking everything and that was the problem. So I put it back in its slot and that fixed it!

 

Yah... that's the ribbon cable that connects the CD changer and pre-amp to the control board!!!

Look for this at the base of the unit