i have a bulk pack but havent installed it yet.

a couple questions:

how did you put it on the doors? did you just take off the door panel and put it there? or did you take off the door panel, the panel under that, the window, and then do that part?

how did you get metal cuts?

do you think one bulk pack will do the doors and the trunk upper and lower?

 

Im Just Now Healing From My 6 Or So Metal Cuts As Well! Ouch They Were Deep ...gloves Must Be Thin Enough To Use Fingers Well Though. That Spare Tire Well That Takes Another Couple Hours.

 

1 And A Half Bulk Packs To Do The Lid Properly(twice) And The Doors And Spare Tire Well

 

Its Very Easy--just Make Sure You Stick It On Any Metal Parts(resonance) And Stick It On Good With A Heavy Roller. A Little Elbow Grease(actually A Lot!!!!) And That Is All You Need To Know. But Do It Right The 1st Time So You Wont Have To Take The Door Panels Off Twice! Everytime I Do That Fitment Just Gets Worse...might Wanna Change Speakers Same Time Door Panels Are Out---saves A Lot Of Time Too!
Btw: The Spray Dynamat Stuff....sucks.no Good. Dont Waste Money.