FS[SoEast]: KP Technologies Window UP module NM20
Joined: Feb 2005
Posts: 3,198
Likes: 29
From: Jacksonville & Ft. Lauderdale, FL
KP Technologies Window UP module NM20
Phase 923478 of my part out - audio & electronics
For sale KP Technologies Window-UP module PN NM20
On our cars, we can hold the UNLOCK button to bring the windows down, but we can't make them go back up!! with this module, UP isnt a problem!
Instruction manual : http://www.kptechnologies.com/docs/N...stallation.pdf
SOLD + PP if applicable
For sale KP Technologies Window-UP module PN NM20
On our cars, we can hold the UNLOCK button to bring the windows down, but we can't make them go back up!! with this module, UP isnt a problem!
Instruction manual : http://www.kptechnologies.com/docs/N...stallation.pdf
SOLD + PP if applicable
Last edited by Jamaica2G; Mar 30, 2014 at 11:08 PM.
Joined: Feb 2005
Posts: 3,198
Likes: 29
From: Jacksonville & Ft. Lauderdale, FL
It is fairly simple.
You have to remove two guard plates and the three screws holding the plastic interior door panel in order to remove the door.
Once the door is off, you locate and isolate 5 wires. If you use the wire connector clips from Home Depot, you won't have to cut any wires (I believe that is the suggested method)
Put the door panel back on and enjoy.
Out of 10, I would say 2-4 in difficulty depending on your patience level.
Adrian
You have to remove two guard plates and the three screws holding the plastic interior door panel in order to remove the door.
Once the door is off, you locate and isolate 5 wires. If you use the wire connector clips from Home Depot, you won't have to cut any wires (I believe that is the suggested method)
Put the door panel back on and enjoy.
Out of 10, I would say 2-4 in difficulty depending on your patience level.
Adrian
Thread
Thread Starter
Forum
Replies
Last Post
BradMD_96
Engine, Drivetrain & Forced-Induction
7
Oct 6, 2015 09:31 AM
Learned Hand
G35 Sedan V35 2003-06
1
Oct 1, 2015 09:02 AM