Anyone local to San Diego that has done this before that would be willing to give me a hand. I'm sure I could do it myself, but experience (doing it before) always beats treading into untested waters. Shoot me a PM if you can. Thanks.

 

Thanks for the info completed the job in 15 minutes. And electric tape works great on the shaft.

 

Very useful. Im worried about trying to install mine with all the comments saying how hard it was.

 

Nice!

 

I've tried removing the stock **** for around 45 minutes now and it's really starting to annoy me! For starters i can't get the cover off because of the plugs connected to it and i cannot get my arm in there to disconnect those.
I managed to get a clamp underneath and ontop but as i saw someone post earlier the original **** is starting to wear because i've been turning so hard. Feedback would be appreciated how to overcome this!

 

20 minutes later i managed to undo it and fit the new ****

 

how to pull the shift boot down