Some suspension mods...pics to share (01/26)
Joined: May 2003
Posts: 2,395
Likes: 7
From: San Diego Area
still not on the ground. need to get the bushing at the rear spring perch replaced cause of the heat during powdercoat.
but i can see where the endlinks can fail with adjustable aftermarket sways and will most likely be replacing those in the very near future.
but i can see where the endlinks can fail with adjustable aftermarket sways and will most likely be replacing those in the very near future.
Registered User
Joined: May 2005
Posts: 302
Likes: 0
From: Torrance, CA
Originally Posted by drsifu1
First pic show my stupid a$$ elongated the camber bolt hole for the toe bolt 
. What a waste of time. Next time I'll read the instructions.
. What a waste of time. Next time I'll read the instructions.i've heard 3 different opinions...
1)don't do it, it's not necessary
2)make an oval shaped hole to give greater toe ajustments possible.
3)only elongate one hole on each side of the car instead of elongating all 2 holes on each side.
can someone clarify this issue? and if i need to elongate the holes, does anyone have before and after pics?
thanks
Thread
Thread Starter
Forum
Replies
Last Post