Tein Basic question
Originally Posted by spinn
I've been wanting to go with the Basics too, but wasn't really planning on lowering, as I think my stock height is good enough. Just want tighter suspension. So one can expect to lower up to 0.8" without requiring camber correction?
It's that magic point where some say they can get within oem spec and other's cannot. Since it's about a even split it's better to advise for the worst so owners can be prepaired for the worst. It also brings up the issue that for some, they find the numbers are out, but close enough that they can't justify the cost to correct in the front.
The highest you can set a coupe to ride height wise with Basics is -.7"/+.2" That mean's a awfull lot of spring preload in the front to do that. Tein recommends the car be set to a -1.5"/-.9" drop.
Thread
Thread Starter
Forum
Replies
Last Post
joel extreme
SOCAL Meetings & Events
0
Aug 7, 2015 03:09 AM
netcbc
Steering & Suspension CDN
0
Jul 24, 2015 11:25 AM
joel extreme
SOCAL Meetings & Events
3
Jul 23, 2015 04:13 AM
