Just dropped my car and...
#1
Just dropped my car and...
I just dropped my car with a full set of coilovers, I took the spring out of the spring perch and closed it back up. I think I threw the alignment off real bad by taking it off, I understand when you lower your car you get camber this isn't the first time I dropped my car. And I do know I need a camber kit, and get a alignmeent.
My issue is that I expected the wheel to be slanted a lot because I dropped it a lot and the camber will get thrown off, but not only is the wheel slanted, iThe rear wheel looks like is making a left turn. Will a alignment fix that issue as well? I had to get the spring out of the spring perch so I loosened 2 17mm bolts one connected to the rotor, and the other bolt that the spring perch is connected too that has the bushing.
Cliffs:
Dropped the car on full coilovers
Camber is off
I need an alignment
The rear wheels look like its making a left and a right turn.
I'm wondering if the rear wheels will get fixed if I get an alignment.
My issue is that I expected the wheel to be slanted a lot because I dropped it a lot and the camber will get thrown off, but not only is the wheel slanted, iThe rear wheel looks like is making a left turn. Will a alignment fix that issue as well? I had to get the spring out of the spring perch so I loosened 2 17mm bolts one connected to the rotor, and the other bolt that the spring perch is connected too that has the bushing.
Cliffs:
Dropped the car on full coilovers
Camber is off
I need an alignment
The rear wheels look like its making a left and a right turn.
I'm wondering if the rear wheels will get fixed if I get an alignment.
#4
#5
god, i have mean toe then, i had decent tires about 50% and I was driving 10 miles and all the wires are now showing. I literally mean ALL THE WIRES. I didn't realize it until my friends behind me said it looks like my tires are flat. Looks like someone just took a scissor and cut off all my thread and shaved it.
Thread
Thread Starter
Forum
Replies
Last Post
Hasanbaloch
Engine, Drivetrain & Forced-Induction
15
02-29-2024 08:45 PM