Probably but I havn't tried that combination myself.
The bars will fit like stock though.

 

I like Motordyne because of the service Tony provides to the G community. The stiffer the bar, the more likely the end links will make noise. My car is also lowered an inch, so that combined with the Motordyne sways set to Med was too much for the stock end links. The SPL end links rattle, but it is only noticeable at low speeds, like in a parking lot. If I was doing it again, I'd try a different brand of adjustable end links.

You experience could be different, especially if you aren't lowered. I recommend getting the sway bars installed first, then see if the end links make noise.

 

Thanks for the tip. I already ordered SPL Pro Outer Tie Rod End and SPL PRO Rear Endlinks due to a recommendation from my shop... Rattle at low speeds .. Everyone is running Hotchick so I was just wondering if there was a reason

 

how long do these take to install and is it a easy DIY? what would a shop charge?

Do i need to buy bushings to install these or will they bolt right up with out issues?

 

Its an easy install. Shouldn't take more than an hour. The kit comes with everything you need for a complete installation.

 

Got my sway bars today. Just wondering is the front bar supposed to be thicker than the rear? In the product picture, it doesn't seem so.

 

Why are the black ?

 

Just the lighting, white balance is a bit off. Fixed the original pic with correct colors.

 

Yup, front bar is much thicker, all normal, that's the same as stock style, the front being thicker.

Enjoy, these are great bars

 

Anyone have a set they wanna get rid of?

 

can anyone else confirm that the newest bars only have two holes on the front sway? is it just mine?

 

yes.

 

Correct. The 3rd hole was so close to stock it was redundant.

 

Still available?

 

Should be, give 'em a call.