Hey all,

I'm trying to see what everyone is running with what drops for alignment spec.

Here is my spec sheet with about 3 inch drop:


The goal is for me to see if I can get closer to spec.

Thanks

 

Toe = within spec

Caster = within spec

Camber = -3.50 F & -3.75 R

 

toe and caster in spec

camber -3.5/-5.5

 

i don't know exactly how much of a drop I have but,



toe = 0 front and back

camber front = -3

camber rear = -3.5

 

I think my next set I'm gonna run stock alignment settings and no fender work.. my rear fender lip is grinded smooth.. just sit flush..

 

At the time of my last alignment I was lowered about 1.5" front and rear.

Front:
Camber 2.1
Toe: .08

Rear:
Camber 2.2
Toe .13

Im now a little lower so my settings are probably out of spec, but ill be returning soon to get that checked/adjusted.

 

dropped around 2-3 inches and here is my sheet (no camber kit yet)

 

Does anyone who has their toe in spec and dropped couple of inches with -3 degree camber, how did you do it?

 

a camber kit and toe bolts...

 

Got both...need to install my spc toe bolts but I got camber kit in there.

 

so get an alignment before asking questions of how to get toe in stock spec

 

That's your problem. Get your toe bolt in, make sure you extended the hole and you should easily be able to get toe in spec.

 

will do. Thanks all. Just wanted to see if it is possible.

 

Well, I got the SPC toe bolts installed and had an alignment done. Toe is back in spec. Thanks everyone for sharing your specifications.