Hey guys I ordered a pair of rear camber arms and I was sent the wrong ones. The ones I intended to buy were the 72050's with the bend. But I was sent the 72260's which are straight arms. Is it possible for me to use the straight ones or do I need the 72050s?
I have a 2005 G Coupe

 

What do you need?

 

I was told that I needed the 72050 but the vendor that sent me the 72260s said those work just fine.
I'm just wondering if I can actually use the straight arm ones.

 

straight arm ones are better than the bent. just FYI. newest design from SPC.

 

Thanks man, all i needed to hear! I'll be installing these in the next week. I'll post on the What did i do thread, ive done a bit

 

no problem. i have them on my G as well (straight design). The reason the older versions were bent was SPC had some issue where they felt the camber arms would hit the sway bar, or so I heard...But then going back and looking at, they determined this actually was not an issue, thus new straight arm design.

 

Are the straight ones stronger? If so maybe I should change mine out

 

Alright guys, turns out that SPC did change out the design to being the straight arm although, the 72260 is NOT for the G35. I went to the shop today and I found out that they aren't compatible. Those arms for the G37/370Z chassis. So for those of you thinking of swapping them out buy these;
72052.