Vehicle Dynamic Control is The problem

Old May 13, 2017 | 09:34 PM
  #1  
onevq35de's Avatar
Thread Starter
|
Registered User
Joined: May 2017
Posts: 375
Likes: 46
From: Southeast
Vehicle Dynamic Control is The problem

I've had excessive brake dust on my rear wheels. Bad cailpers? No. Many have had this problem. Am I kicking a dead horse? Was this known by most? Sorry if that's the case.
I knew something was wrong when I put on a set of very open wheels. The VDC appears to be the issue. Pulled the fuse/relay and excessive brake dust no more. Potentially better mpg's, acceleration, longer lasting brakes and less fade now that the rear's aren't so damn hot all the time. No wonder Nissan/Infinity chose not to address this issue. Not a cheap fix.
My question; How does one get the dash lights (slip, abs, etc.) off permanently, without accessing the gauge panel?
 
Reply
Old May 14, 2017 | 01:53 AM
  #2  
Blue Dream's Avatar
I drove ttrank's car solo
iTrader: (50)
Joined: Mar 2009
Posts: 18,299
Likes: 1,488
From: By the sea, Tx
G35 sedan w/ too much money in mods
Premier Member

You don't simple answer. People tend to cover it with a piece of electrical tape, TPMS light gets the same treatment for a lot of members as well.
 
Reply
Old May 14, 2017 | 07:55 AM
  #3  
onevq35de's Avatar
Thread Starter
|
Registered User
Joined: May 2017
Posts: 375
Likes: 46
From: Southeast
Thanks BD. Didn't consider tape. I pulled the washer tank, but before doing so I've been driving around with little fluid. Light was on the dash. Pulled the tank & cut the plugs - no more dash light.
Scanguage has no codes saved for the VDC/ABS without the fuse. If I pull the plug from the source, perhaps the lights will **** off? Gonna gi.ve it a shot
 
Reply


Thread Tools
Search this Thread
Rate This Thread
Rate This Thread:
You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 03:20 AM.