Slip/VDC OFF, then RAS. After Suspension Install

Thread Tools
 
Search this Thread
 
Rate Thread
 
Old Jun 12, 2019 | 09:14 PM
  #1  
G35stephen's Avatar
Thread Starter
|
Registered User
Joined: Nov 2017
Posts: 14
Likes: 0
Slip/VDC OFF, then RAS. After Suspension Install

2006 G35 Coupe

Just did a suspension refresh and now I'm throwing Slip/VDC OFF once i hit 25-30 MPH, then RAS joins them after a minute or two of driving. Light all turn off when car is turned off and restarted, then after the 25-30MPH and few min of driving, all lights back on.

Just replaced
- Wheel Bearings
- Control Arms
- Ball Joints
- Tie Rod ends
- Swap Bar End-links
- Sway Bar Bushings

Did not disconnect battery, may have stressed the sensor that bolts to the hub as the knuckle fell forward and was caught by the sensor and the ball joint. Any thoughts are appreciated!

Thank you!
 

Last edited by G35stephen; Jun 12, 2019 at 10:23 PM. Reason: Adding Wheel bearings
Reply
Old Jun 12, 2019 | 09:29 PM
  #2  
cleric670's Avatar
BANNED!!!
Joined: May 2017
Posts: 14,837
Likes: 2,497
From: Washington State
Coupe 6MT Premium RAS
Premier Member

Double check that all those wheel sensors got plugged in properly, unplug them all and check for bent pins and such.
 
Reply
Old Jun 12, 2019 | 09:34 PM
  #3  
G35stephen's Avatar
Thread Starter
|
Registered User
Joined: Nov 2017
Posts: 14
Likes: 0
Originally Posted by cleric670@gmail
Double check that all those wheel sensors got plugged in properly, unplug them all and check for bent pins and such.
I'll check the one that's looking at the wheel bearing, that's the only one I messed with?
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Kimochi543
Northern California
5
Jul 7, 2008 11:24 PM
netcbc
Canada
19
Dec 3, 2007 06:10 PM



You have already rated this thread Rating: Thread Rating: 0 votes,  average.


All times are GMT -4. The time now is 08:37 PM.